AEM 4.9 Wideband UEGO Sensor, with connnector (33-2005)

AEM's Bosch 4.9LSU Wideband UEGO O2 replacement sensor kit includes only the sensor (with attached cable and male connector) and is intended to replace an existing mounted wideband sensor used with AEM Digital Wideband UEGO Air/Fuel Controller Part Number 30-4110, 30-0300.

These sensors have a laser-etched, calibrated resistor in the sensor’s connector body. This resistor is specifically created for the exact sensor that it is attached to. Modifying this will invalidate the sensor’s output. The wideband sensor is laboratory-calibrated at the Bosch factory, accurate to 0.1 AFR and never requires free-air calibration when used with an AEM wideband AFR controller.

• Accurate to 0.1 AFR
• Never requires free-air calibration when used with an AEM Controller and connector plug.
• Specifically designed for use with AEM Wideband UEGO controller Part Number 30-4110, 30-0300
• Replacement sensor and weld on bung only

Replacement Sensor for the following AEM Wideband Controller

• 30-4110 - Digital Wideband UEGO Gauge
• 30-0300 - X-Series Digital Wideband UEGO Gauge

All other AEM Wideband Controllers please refer to the 30-2001 Bosch LSU 4.2 Replacement Sensor

Contents includes:
Bosch LSU 4.9 Wideband UEGO Sensor, Weld-On Bung

This part number AEM 30-2005 can be used with the Link G4+ Fury ECU etc